Colonnade Association Pool

The turnover is not adequate for the pool. The required turnover is 138 gpm. The equipment for a swimming pool shall be of adequate size to turn over the entire pool water capacity. The turnover rate for pools constructed after the adoption of this chapter shall not exceed the sum of one and one-half times the average water depth in feet; where the number of hours is equal to the number feet calculated, or exceed once every six hours whichever is less. Unless the rate is otherwise specified in subsection (b) below. This system shall be designed to give the proper turnover rate based on the manufacturer's recommended maximum pressure flow of the filter in dirty media condition of the filter, immediately prior to cleaning the filter. Turnover rate must be met on next routine inspection.

Upon arrival for inspection, the gate was propped open with a rock. There were no bathers present at the time. When the rock is removed, the gate does not self close when opened at different angles. Tighten the springs or perform other maintenance to ensure the gate self closes when opened.

The pH exceeds maximum value of 7.8 during operation. Ensure the pH concentration remains between 7.2-7.8.

An incorrect vacuum line fitting is present. The vacuum line shall be protected with a self-closing, self-latching fitting that complies with the current IAMPO SPS 4- Special Use Suction Fitting for Swimming Pools, Spas and Hot Tubs.

The turnover is not adequate for the pool. The required turnover is 138 gpm.

There is no rope and float line present to indicate the slope change from the shallow to the deep end of the pool. Rope and Float Line. A rope and float line shall be provided within one foot of and on the shallow side of the break in grade between the shallow and deep portions of the swimming pool, with its position marked with visible floats at intervals of seven feet or less.

There is no contrasting color stripe present at the slope break from the shallow to the deep end of the pool.

There are some depth markers missing on the pool deck. Depth markers shall be installed at the maximum and minimum water depths and at all points of slope change. (e) Depth markers shall be installed at intermediate increments of water depth of two feet or less, and shall be spaced at intervals of twenty-five feet or less. (f) Depth markers shall be arranged uniformly on both sides and both ends of the pool. (g) Depth markers on irregularly shaped pools shall designate depths at all major deviations in shape.

There is a floor inlet cover that is missing. Ensure all inlets are properly covered to prevent a hazard to the bather.

An incorrect No lifeguard on duty sign is posted. Where no lifeguard is on duty, a sign or signs shall be placed in clear view at or near the entrance to the pool and shall state in clearly legible letters at least four inches high “WARNING - NO LIFE GUARD ON DUTY and RISK OF DROWNING - SUPERVISE CHILDREN CLOSELY”.

Not all the required pool risks are posted. See email for guidance on signage.

Provide records of daily water testing