EMBRY HILLS CLUB

13-190 (a): The equipment shall be operated continuously on a 24 hour basis to obtain the minimum required turnover of 1 every 6 hours for a standard pool. Flow meter read 120 gpm instead of required 222.22 gpm.

13-190(a)/13-205(B)(1) Observed flowrate below the minimum required turnover rate of 222 GPM for an 80,000 gallon pool. The equipment shall be operated continuously on a 24 hour basis to obtain the minimum required number of 4 turnovers per day.

13-190(a)/13-205(B)(1) Observed flowrate below the minimum required turnover rate of 222 GPM for an 80,000 gallon pool. The equipment shall be operated continuously on a 24 hour basis to obtain the minimum required number of 4 turnovers per day.

13-200(a) Observed unsecured light bulb in the deep end of the pool. Electrical wiring fixtures and installation shall conform to all applicable state, county and local building code requirements.

13-190(a): Equipment must be operated on a 24 hour basis to obtain the minimum requirement of 6 turnovers per day. Observed: Flow meter does not appear to be working, reads 0/.

13-189(c)(2): Cyanuric acid levels must not exceed 100ppm. Observed: 104 ppm.

13-202(a)(2): Entry to the pool should be through a self-closing, self-latching gate. Observed: Gate does not fully close or latch on its own.

13-184(e)(5): Unsecured handrails are considered an imminent health hazard. Observed: Handrail on pool stairs can be pulled out of the ground. Corrected on site.

13-205(b)1 Observed flow meter reading 175 gpm which does not allow for one turn lever every 6 hoods or less.

13-190(a)- Equipment shall obtain adequate turnover rate. Flowmeter reads 90 GPM. Needs to be at least 222 GPM.

13-196(a)(4)- Skimmers shall be operational and provide effective skimmers. Observed most of the skimmers clogged with debris.

13-190(a)- Flow meter shall be at minimum requirement. Requirement is 222 gpm. Flow meter read a little below 180 gpm.

13-184 (e)(5)- Facilities must be maintained and in clean, sanitary condition.