VIA 14 Restaurant

Observed food and drinks being consumed by the cook stored in the food preparation area. PIC corrected on site.

511-6-1.03(5)(k)1&2 - Eating, Drinking, or Using Tobacco (C) (k) Hygienic Practices.

1. Employees shall not use any form of tobacco products, or electronic devices that simulate tobacco smoking, while engaged in food preparation or service, nor while in areas used for equipment or utensil washing and storage, food preparation or food storage. Employees shall only use tobacco products or electronic devices that simulate tobacco smoking in approved designated areas.

2. Employees shall consume food only in approved designated areas separate from food preparation and serving areas, equipment or utensil areas and food storage areas. However, drinking from a single service beverage cup with a secure lid and straw that is handled to prevent contamination of the employee’s hands, the container, exposed food, clean equipment, utensils and linens, unwrapped single-service and single-use articles will be allowed.

Observed excessive mold build up on the soda gun nozzles. PIC corrected on site by removing and properly washing, rinsing, and sanitizing the nozzles (COS).

511-6-1.05(7)(b) - Food Contact Surfaces and Utensils - Cleaning Frequency (P, C) (b) Equipment Food-Contact Surfaces and Utensils.

1. Equipment food-contact surfaces and utensils shall be cleaned:

(i) Before each use with a different type of raw animal food such as beef, fish, lamb, pork, or poultry. It does not apply if the food-contact surface or utensil is in contact with a succession of different types of raw meat and raw poultry each requiring a higher cooking temperature as specified under DPH Rule 511-6-1.04(5)(a) than the previous type such as preparing raw pork followed by cutting raw poultry on the same cutting board; P

(ii) Each time there is a change from working with raw foods to working with ready-to-eat foods; P

(iii) Between uses with raw fruits and vegetables and with Time/Temperature Control for safety food; P

(iv) Before using or storing a food temperature measuring device; P and

(v) At any time during the operation when contamination may have occurred. P

2. Except as specified in paragraph 3 of this subsection, if used with time/temperature control for safety food, equipment food-contact surfaces and utensils shall be cleaned at least every 4 hours throughout the day. P

3. Surfaces of utensils and equipment contacting time/temperature control for safety food may be cleaned less frequently than every 4 hours if:

(i) In storage, containers of time/temperature control for safety food and their contents are maintained at temperatures specified under DPH Rule 511-6-1-.04 and the containers are cleaned when they are empty;

(ii) Utensils and equipment are used to prepare food in a refrigerated room or area that is maintained at one of the temperatures in the following chart and:

(I) The utensils and equipment are cleaned at the frequency in the following chart that corresponds to the temperature:

Temperature Cleaning Frequency

41ºF (5.0ºC) or less 24 hours

41ºF - 45ºF (>5.0ºC - 7.2ºC) 20 hours

45ºF - 50ºF (>7.2ºC - 10.0ºC) 16 hours

50ºF - 55ºF (>10.0ºC - 12.8ºC) 10 hours

and

(II) The cleaning frequency based on the ambient temperature of the refrigerated room or area is documented in the food service establishment.

(iii) Temperature measuring devices are maintained in contact with food, such as when left in a container of deli food or in a roast, held at temperatures specified under DPH Rule 511-6-1- .04;

(iv) Equipment is used for storage of packaged or unpackaged food, such as a reach-in refrigerator, and the equipment is cleaned at a frequency necessary to preclude accumulation of soil residues;

(v) The cleaning schedule is approved based on consideration of:

(I) Characteristics of the equipment and its use,

(II) The type of food involved,

(III) The amount of food residue accumulation, and

(IV) The temperature at which the food is maintained during the operation and the potential for the rapid and progressive multiplication of pathogenic or toxigenic microorganisms that are capable of causing foodborne disease; or

(vi) In-use utensils are intermittently stored in a container of water in which the water is maintained at 135ºF (57ºC) or more and the utensils and container are cleaned at least every 24 hours or at a frequency necessary to preclude accumulation of soil residues.

4. Dining counters and table-tops shall be cleaned and sanitized routinely after removing all soiled tableware and food trays shall be cleaned and sanitized after each use by one of the following methods:

(i) A two step method in which one cloth, rinsed in sanitizing solution is used to clean food debris from the surface and a second cloth in separate sanitizing solution is used to rinse;

(ii) Sanitizing solution is sprayed onto the surface and the surface is then wiped clean with a disposable towel;

(iii) If used for cleaning and sanitizing, single-use disposable sanitizer wipes shall be used in accordance with EPA-registered label use instructions; or

(iv) Other methods approved by the Health Authority.

(v) Food trays may be cleaned and sanitized the same as table ware.

5. Except when dry cleaning methods are used as specified under subsection (7)(e) of this Rule, surfaces of utensils and equipment contacting food that is not time/temperature control for safety food shall be cleaned:

(i) At any time when contamination may have occurred;

(ii) At least every 24 hours for iced tea dispensers including nozzles and consumer self-service utensils such as tongs, scoops, or ladles;

(iii) Before restocking consumer self-service equipment and utensils such as condiment dispensers and display containers; and

(iv) In equipment such as ice bins and beverage dispensing nozzles and enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment:

(I) At a frequency specified by the manufacturer; or

(II) Absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold.

Observed raw beef being thawed improperly in the meat preparation sink. Raw beef was thawing in the sink without cold running water. PIC corrected on site.

511-6-1.04(6)(c) - Thawing (C) (c) Thawing. Except as specified in paragraph 4 of this subsection, time/temperature control for safety food shall be thawed:

1. Under refrigeration that maintains the food temperature at 41°F (5°C) or less; PF or

2. Completely submerged under running water:

(i) At a water temperature of 70°F (21°C) or below, PF

(ii) With sufficient water velocity to agitate and float off loose particles in an overflow PF, and

(iii) For a period of time that does not allow thawed portions of ready-to-eat food to rise above 41°F (5°C), or

(iv) For a period of time that does not allow thawed portions of a raw animal food requiring cooking to be above 41°F (5°C), for more than 4 hours including:

(I) The time the food is exposed to the running water and the time needed for preparation for cooking PF, or

(II) The time it takes under refrigeration to lower the food temperature to 41°F (5°C) PF;

3. As part of a cooking process if the food that is frozen is:

(i) Cooked as specified under subsections (5)(a)1 or 2 or (5)(b) or 5(e) of this Rule PF, or

(ii) Thawed in a microwave oven and immediately transferred to conventional cooking equipment, with no interruption in the process PF; or

4. Using any procedure if a portion of frozen ready-to-eat food is thawed and prepared for immediate service in response to an individual consumer's order.

5. Reduced oxygen packaged fish that bears a label indicating that it is to be kept frozen until time of use shall be removed from the reduced oxygen environment:

(i) Prior to its thawing under refrigeration that maintains the food temperature at 41°F (5°C) or less; or

(ii) Prior to, or immediately upon completion of its thawing, using procedures to completely submerge in running water as specified in paragraph 2 of this subsection.

Lasagna and refried beans not covered in the walk in cooler. Sauce stored below the vegetable sink was uncovered.

511-6-1.04(4)(q) - Food Storage (C) (q) Food Storage.

1. Except as specified in paragraphs 2 and 3 of this subsection, food shall be protected from contamination by storing the food:

(i) In a clean, dry location;

(ii) Where it is not exposed to splash, dust, or other contamination; and

(iii) At least 6 inches (15 cm) above the floor.

2. Food in packages and working containers may be stored less than 6 inches (15 cm) above the floor on case lot handling equipment if the equipment can be moved by hand or by conveniently available apparatuses such as hand trucks and forklifts.

3. Pressurized beverage containers, cased food in waterproof containers such as bottles or cans, and milk containers in plastic crates may be stored on a floor that is clean and not exposed to floor moisture.

Employee must wash hands signs needed at all hand sinks (Repeat).

511-6-1.07(3)(d) - Handwashing Signage (C) (d) Handwashing Signage. A sign or poster that notifies food employees to wash their hands shall be provided at all handwashing sinks used by food employees and shall be clearly visible to food employees.

Observed the current food permit not posted.

511-6-1.02(1)(f)(1) - Permit, Displayed (C)

1. Post the permit in a location in the food service establishment that is conspicuous to consumers

Observed an employee must wash hands signed not provided in the restroom. PIC will install the employee's must wash hands sign by 12/15/25.

Observed the walk in cooler floor in bad repair. The floor tile is cracked. PIC will repair the walk in cooler floor by 02/15/25.

511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation.

(a) Good Repair. All physical facilities shall be maintained in good repair.

(b) Cleaning, Frequency and Restrictions.

1. The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products.

2. Except for cleaning that is necessary due to a spill or other accident, cleaning shall be done during periods when the least amount of food is exposed, such as after closing.

3. If present, playground equipment and associated areas shall be maintained in a clean and sanitary condition. In addition, a cleaning and sanitizing plan along with cleaning and sanitizing records for playground equipment and associated areas shall be maintained within the food service establishment for review upon request by the Health Authority. Further, such cleaning and sanitizing plan for employees to follow in the event of encountering vomitus or fecal matter shall be included and submitted at the time of permit application as specified in DPH Rule 511-6-1-.02(1)(c). Pf

Observed slime and a mold like build up in the ice bin. PIC will cease using ice in the ice bin until a deep cleaning is completed. The deep cleaning will be completed by 5/15/25

Observed build up on vents in the restroom. PIC will clean the vents by 5/15/25 to allow proper ventilation.

Observed front door does not have a self closure.

Reach in cooler gasket in bad repair

Shelves in the seasoning storage area dirty. Shelves in the walk in cooler contained build up.

Raw shelled eggs stored above cooked potatoes in the walk in cooler

Mold build up observed on ice bin and soda gun in the bar area.

Observed packaged raw tilapia thawing on the meat sink drain board at room temperature.

Hood plates missing in the hood vent

Observed TCS food cold being cold held greater than 41 degrees Fahrenheit. Beans and chicken dated 11/5/2023 were observed at 45 degrees in the walk in cooler. Queso observed in the walk in cooler at 43 degrees F. PIC discarded beans that did not meet temperature requirements. The walk-in coolers temperature was 45 degrees f

Observed shrimp, sauce, and shrimp not covered in the walk in freezer

Mold build up observed on ice, soda nozzles, and the soda gun in the bar area. Observed cheese slicer stored with cheese left in the interior of the slicer

Ice build up behind the cooler and freezer fans