Alpharetta, Fulton County

La Parrilla

865 NORTH MAIN ST ALPHARETTA, GA 30004

Food
Latest score
100
Jan 14, 2026
City
Alpharetta
County
Fulton
Inspections
3

Score history

Inspection scores over time for this facility.

Inspection history

Georgia inspection history is score-based, with violations grouped under each recorded inspection.

Jan 14, 2026

Routine

Score: 1000 violations
No violations recorded for this inspection.

Nov 13, 2024

Routine

Score: 1000 violations
No violations recorded for this inspection.

Aug 15, 2023

Routine

Score: 902 violations

6-1A - proper cold holding temperatures

Regulation: 511-6-1.04(6)(f) - time/temperature control for safety; cold holding (p)

9 ptsCorrected: NoRepeat: No

Observed several TCS items on the grill prep line PTC and in the WIC that were out of temp. See temp log for readings. PIC also confirm that their WIC was in need of service at the time of the inspection. Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C) or below or 135°F (57°C) or above, except that roasts cooked to a temperature and for a time specified in subsection (5)(a)2 of this Rule and reheated using the same temperature and time conditions as cooking may be held at a temperature of 130°F (54°C) or above. PIC will discard these items and voluntarily close until their WIC is fixed.

15A - food and nonfood-contact surfaces cleanable, properly designed, constructed, and used

Regulation: 511-6-1.05(2)(c) - multiuse food-contact surfaces (pf)

1 ptsCorrected: NoRepeat: No

Observed several heavily scored cutting boards on the grill prep line.

  1. Multiuse food-contact surfaces shall be: (i) Smooth; Pf (ii) Free of breaks, open seams, cracks, chips, inclusions, pits, and similar imperfections; Pf (iii) Free of sharp internal angles, corners, and crevices; Pf (iv) Finished to have smooth welds and joints; Pf and (v) Except as specified in paragraph 2 of this subsection, accessible for cleaning and inspection by one of the following methods: (I) Without being disassembled, Pf

(II) By disassembling without the use of tools, Pf or

(III) By easy disassembling with the use of handheld tools commonly available to maintenance and cleaning personnel such as screwdrivers, pliers, open-end wrenches, and Allen wrenches. Pf PIC will discard and replace all of the scored cutting on the prep line.